VC3 PRO Channel V2 power supply question

[Mike77]

Hoping someone can verify that I have the correct "wall wart" power supply for my VC3 PRO Channel V2.

It's a Condor model number A12-1A. It is marked as 120V input, 12VAC 1000mA output. Definitely has the correct connector to mate up with the unit. I can post a pic if that will help identify it.

Also, in case it matters, the serial number of my VC3 is 104751.

When I moved to a different location, a bunch of power supplies were mixed together. Just want to be sure I am matching it up correctly. Once I verify that I have it right, I'll mark it so it will be clear from now on. Been doing that with others in a process of elimination.

Thanks in advance,

Mike
Baltimore, MD

[hargerst]

According to the owner's manual, that should be the right power supply.

[Mike77]

Thank you. I appreciate the quick reply.

Thanks again,

Mike

[Alan Hyatt]

Thanks Harvey....

[hargerst]

Thanks Harvey....Always glad to help when I think I know the answer.










(and that explains why I post so infrequently.);)

[CipVon]

Wireless cards use negligable power, its not an issue.

I had 2 optical drives, 4 hard drives, 5 PCI cards and a 9700 pro on a 400W power supply.

Then again, that was the power supply that blew... but it was generic.

[Ausrock]

Wireless cards use negligable power, its not an issue.

I had 2 optical drives, 4 hard drives, 5 PCI cards and a 9700 pro on a 400W power supply.

Then again, that was the power supply that blew... but it was generic.


Huh?:confused:

[hargerst]

Wireless cards use negligable power, its not an issue.

I had 2 optical drives, 4 hard drives, 5 PCI cards and a 9700 pro on a 400W power supply.

Then again, that was the power supply that blew... but it was generic.
Well, yeah, when you put it that way.

[Alan Hyatt]

:confused: